DCC Specialties Jack Light Quad

DCC Specialties Jack Wabbit Light Quad with LocoNet for Snap Coil Low Voltage

Compatible with Many Types of Turn-Out Motors including:

• Circuitron Tortoise


• Kato Snap


• Rapido RailCrew


• DCC Concepts Cobalt


• Atlas Solenoid


• Peco Solenoid

The Jack Light is a version of our popular Jack Wabbit Quad Stationary Decoder. The Jack Light has four fully functional intelligent decoders on one printed circuit board. The key feature of the Jack Light is the ability to use up to 8 optical sensors to detect train position. Each sensor, when covered or uncovered, can position all 4 switch outputs to Clear, Throw, or No Change and to set the 4 LED outputs to Red, Green, or No Change.

Jack Light Quad: 4 Outputs on one Stationary Decoder:

• Auto Throw™: Automatically throws points when a train is approaching against the points.


• Smart Route™: Sets up to 6 routes by simple address programming in addition to the primary address.


• Locked Route Control™: Provides for only one route direction response for a Throw or Clear command.


• Smart Default Ops™: Programmed power up response to either power off position, Throw, or Clear.


• Operate Switch Signals or Panel LED Indicators by direct LED connections.


• DCC Reset: CV 63=42, Sets any or all Addresses and CVs to original factory default values.


• Reset Decoder by Jumper: Jumper selection resets entire Jack Light to factory default Address and CV’s.


• Optical Sensor Inputs: 8 optical sensors used to control switch position and LED (signal) status.


• Direct Current Ops: The Jack Light operates on DC using the optical sensors but requires DCC to program.


• Automates Train Routing: From simple Auto Throw to complex yard routing and signaling.