Program CV65=128 [delay=16ms]. CV65 may be any value from 1 to 255. The delay in milliseconds is the CV65 value divided by 8. Ideally CV65 should be the smallest value that consistently works correctly. CV65=128 should work for most layouts.
Input and Output connectors J1 and J2 are designed for use with 12 AWG to 22 AWG wire.
Turn the screw on the connector counter-clockwise while looking at the connector opening
Make sure the wire clamp is at the bottom of the connector opening.
Insert the wire you are connecting and turn the connector screw clockwise to tighten.
If you are using a heavier bus wire such as 10 AWG, solder a short length of 12 or 14 AWG wire to your heavier bus to connect to the PSX-AR terminal.
We recommend rail drops to the track bus every 3-5 feet. Insufficient feeders can cause your track voltage to be significantly lower than your booster output voltage.
When wiring more than one PSX or PSX-AR [PSX-2, PSX-3 PSX-4, PSX-AR etc.] insure all input/output polarities are the same
Search Article Content
Chose from preferred categories below to refine your search results. Use (+) to add more options
1991-2018 all rights reserved | Site by tdcollins.com | Site Maintained by Bytes.co