Search results for:
September 30 2015
Reset A PSX-AR with Digitrax
Ever feel that you're lost and need to reset your PSX-AR unit? Here's the exact procedure to restore to factory defaults with your Digitrax DCC system. Also included is how to assign the address for controlling a turnout with the PSX-AR.
- Make sure you have installed the Digitrax configuration jumper J7-3 to J7-4
- Turn off the DCS51, connect the PSX-AR, and move the program jumper to program
- Turn on the DCS51 or other Digitrax System
- You will see D6 flash; hopefully long/short, but this is not critical
- Press PROG MODE until you see OPS displayed
- Press STEPS CV, you see o001 (number may be different)
- Press 63 then CV and see d000 (number may be different)
- Press 42 then CV-WR
- Make sure you see D6 flash
- You are now reset
- Press EXIT
- Press SWITCH and the address you want (e.g. 100)
- Press either t or c
- Make sure you see D6 flash
- The switch control will be at the address you used (e.g. 100) plus 2 (e.g. 102)
- Turn of track power and place the jumper back to normal
- Turn on track power. The PSX should turn on (c) and off (t) at the switch address you programmed
- The switch control should operate (t/c) at the address you programmed plus 2