DH-104 - 1.0 Amp rated with 4 functions designed for Atlas, Kato, and Stewart locomotives.

[go to SystemOne catalog page]

• Compatible with the NMRA Standards and Recommended Practices
• 1.4 Amp overall current capacity
• 1.0 Amp motor capacity for permanent magnet type DC motors
• 0.4 Amp (400 mA) minimum for the functions (100 mA maximum per function)
• specifically designed to fit Kato, Atlas, and Stewart and Proto 2000 locomotives
  
  Atlas locomotives
  RS1 RS3 RS11 RSD12 RSD4 RSD5
  GP7 C424 C425 U33 U36 C30-7
  and any new loco using the same PC board as the U33/6.
  
  Kato locomotives
  GP-35 SD-40 C44-9
  
  Stewart locomotives
  F3, F7 and F9 (all phases, both A and B units)
  (FT's with a little work)
  
  Proto 2000
  SD7 SD9
  
  
• Slip-on connectors or solder
• function animation for F2 and F3
• overload protected
• 3 programmable addresses - Short (7 bit) address for backward compatibility, Long (14 bit) address for assigning any number to 9999, Consist (7 bit) address for assigning to a consist
• operates on DC
• programmable speed curve with both standard table and individual point capabilities
• programmable starting voltage
• programmable momentum for acceleration and deceleration, adjustable from immediate to 3.8 minutes from stop to full speed
• operator control of front headlight and rear headlight. Lights do not change with loco direction
• operates with 128 speed step (feels like analog DC control) or 28 speed step with momentum

We welcome comments or suggestions from readers; please write or call.